[Wireless mode settings] Screen/[Wireless mode fixed setting] Screen

iX1300 iX100

This screen is used to change the wireless mode.

This screen consists of the following:

Auto mode

This is for iX100.

Select this option to automatically switch the wireless mode depending on the wireless environment.

In auto mode, when you turn on the ScanSnap, it connects to a wireless access point in Access Point Connect mode.

If the wireless access point that was set in the ScanSnap Wireless Setup Tool is not detected, the Direct Connect mode is used.

HINT

[Auto mode] is selected by default.

If necessary, change the setting.

Access Point Connect mode

Select this option to set the wireless mode to the Access Point Connect mode.

Direct Connect mode

Select this option to set the wireless mode to the Direct Connect mode.

HINT

For iX1300, [Direct Connect mode] is selected by default.

If necessary, change the setting.

[Set] button

Sets the wireless mode.

[Cancel] button

Cancels the settings.

HINT

For iX100, when you select a mode other than Auto mode and then exit the Wireless Setup Tool, an unavailable mode confirmation window appears.