Archived content
NOTE: this is an archived page and the content is likely to be out of date.
Outside Designated Scan Area Error
This error occurs when you perform scanning with the ADF and the bottom edge of the document is detected before the specified area is scanned.
Example:
Outside of the document may have been scanned because the scanned document is shorter than the specified paper size. Perform one of the following, and then scan again.
- Load a document of the specified paper size in the ADF paper chute (feeder)
- Change the scan settings so that the scan area is set inside of the document
ATTENTION
Ways to designate the scan area differ depending on the application. For details, refer to the application manual.
