Selecting a Computer from [Connect to] to Establish a Connection

You can select a computer from [Connect to] in the following cases:

  • When multiple computers are available and you are connecting to a different computer

  • When [Do not connect] is displayed for [Connect to] in the [Settings] screen

When you tap a destination from [Connect to] in the [Settings] screen, the [Connect to] screen appears.

The [Connect to] screen shows the following information that is detected in the same network:

  • Names of the computers

  • IP addresses of the computers

  • Names that are set for iX1600, iX1500, iX1300, iX500, or iX100

  • IP addresses of iX1600, iX1500, iX1300, iX500, or iX100

List of Destinations

Checkmark will appear next to the computer that is connected.

  1. Tap Settings Button on the [File List] screen or do the same thing on the folder screen with the ScanSnap Sync function set to on.

    The [Settings] screen appears.

  2. Tap a destination under [Connect to].

    The [Connect to] screen appears.

  3. Select a computer from [Computer].

    Connection is established with the computer.

HINT

  • If the computer does not appear, tap [Refresh] to refresh the information on the list.

  • If you do not know the name of the computer, confirm it with [Computer name] in the [Scan to Mobile] window on the computer.

  • When you select [Specify IP address], you can specify the IP address of the computer.

  • To connect the mobile device to iX1600, iX1500, iX1300, iX500, or iX100, refer to Connecting the ScanSnap.