Setting an IP Address for the ScanSnap

To identify your ScanSnap on a network, set an IP address for the ScanSnap.

When setting an IP address, [Access point connection] needs to be selected for Wi-Fi connect mode temporarily.

Press in the home screen on the touch panel of the ScanSnap to display the [Settings] screen. Press in the home screen on the touch panel of the ScanSnap to display the [Settings] screen.
Press [Wireless settings] to display the [Wireless settings] screen. Press to display the [Wi-Fi settings] screen.
Press [Wireless access point/router setting] to display the [Wireless access point/router setting] screen. Press [Access point connection] to display the [Access point connection] screen.
Press [IP address] to display the [IP address] screen.
Press the setting field for [Configuration method] to display a list.
Set an IP Address.

When obtaining an IP address from the DHCP server and automatically assigning it to the ScanSnap, select [Obtain automatically (DHCP)].

When setting an IP addresses manually, select [Configure IP address manually] and configure the following settings.
1. Press the input field for [IP address], enter the IP address, and then press [OK].
2. Press the input field for [Subnet Mask], enter the subnet mask, and then press [OK].
3. Press the input field for [Default Gateway], enter the default gateway, and then press [OK].
Press to return to the home screen. Press to return to the home screen.

The IP address is set for the ScanSnap.

TIP

If there is a device with the same IP address as the ScanSnap on the network, is displayed on the [Wireless settings] icon in the [Settings] screen. Change the IP address which has been set for the ScanSnap to avoid an IP address conflict on the network.
If there is a device with the same IP address as the ScanSnap on the network, is displayed on in the [Settings] screen. Change the IP address which has been set for the ScanSnap to avoid an IP address conflict on the network.

See also