Setting Up the ScanSnap That You Purchased as a Replacement or as an Additional Scanner

The following preparations are required before you set up the ScanSnap.

• Check that all items are included in the package

  • Package List

• Remove the materials used for protection from the ScanSnap

  For details, refer to Getting Started that is supplied with the scanner.

• Remove the protective inner cover, tape , and the cardboard sheet from the ScanSnap

  • For ScanSnap iX1600

    

  • For ScanSnap iX1600 Receipt Edition

    

• Remove the protective inner cover, tape , and the cardboard sheet from the ScanSnap

  

• Remove the protective inner cover, tape , and the cardboard sheet from the ScanSnap

  

• Remove the tape seal and tape from the ScanSnap

  

• Remove the tape and tape seal from the ScanSnap

  

• Remove the tape seal from the ScanSnap

  

• Remove the tape seal and tape from the ScanSnap

  

• Connect the ScanSnap and the computer with a USB cable, and charge the battery until the battery indicator light turns off

  
  ATTENTION

  • Do not open the feed guide until the instructions are displayed on the window for installing software.

  • It is recommended to use the supplied USB cable, but you can also charge the ScanSnap using your own USB power adapter.

• Attach the extenders to the ScanSnap

  ATTENTION

  • The following preparations are required before you attach the extenders.

    • Wipe off dust and dirt such as oily dirt on the place where the extenders will be attached

    • Peel the protective tape off the bottom of the extenders

  Leaving about 3 to 5 mm of space between the extenders and the back and side of the ScanSnap, push the extenders down until they lock in place. If the extenders are placed against the side of the ScanSnap base or the protrusion of the extenders are placed on the ScanSnap base, the bottom of the extenders may not stay in place firmly.