This website is designed to be used with ScanSnap Home 2.xx.
If you are using ScanSnap Home 3.0 or later, refer to here.
Setting an IP Address for the ScanSnap
To identify your ScanSnap on a network, set an IP address for the ScanSnap.
When setting an IP address, [Access point connection] needs to be selected for [Wi-Fi connect mode] temporarily.
The IP address is set for the ScanSnap.
ATTENTION
If there is a device with the same IP address as the ScanSnap on the network,
is displayed on
in the [Settings] screen. Change the IP address which has been set for the ScanSnap to avoid an IP address conflict on the network.